Well Pump & Pressure Tank Service near Yakima, WA

How the system works

The well pump fills a pressure tank, which holds water under air pressure so the pump doesn't start every time you open a tap. A pressure switch turns the pump on when pressure drops and off when it reaches the set point.

Short cycling

If you hear the pump click on and off every few seconds while a tap runs, the pressure tank has probably lost its air charge or its bladder has failed. Short cycling wears out pumps quickly, so it's worth fixing promptly.

Low or no pressure

Check the breaker for the pump first. If it's on and there's still no water, the pressure switch, the pump or the wiring may have failed. On older systems, a clogged sediment filter can also choke the flow to the house.

Water quality changes

Cloudy water, sand in the aerators or a sudden change in taste can point to a problem in the well or the pump. Have the water tested if anything changes, and tell the plumber what you noticed and when.

Freeze protection

A well house or pump pit needs protection in winter. A small heater, insulation or a heat lamp kept safely clear of anything that burns can stop a freeze from splitting the pressure tank or fittings.

Getting help

Tell the plumber what you hear, what the pressure gauge reads if you have one, and whether the breaker has tripped. Send a request and a plumber will get in touch.

Keep a record

Note the date the pressure tank was installed, the switch settings and any work done on the pump. When something goes wrong, those details help the plumber decide quickly whether a part can be adjusted or needs replacing, and they're useful to pass on if you ever sell the property.